 |
Here is the final stage of the creation of a CD. It is during the one that one are regulated some parametres as engraving speed, the writing method, the revision... |
Having chosen files to be engraved, click on 'File / Engrave the CD' or on the following icon:
It is necessary to choose first of all an engraving speed. More this one is
élévée and more quickly the CD will be engraved. But prove that the CD on which you are going to engrave is compatible with the chosen speed, especially if this one is
élévée.
Then point out the mode of engraving. To know choose whom between
Disk at Ounce or
Track at Ounce, refer to following explanation:
Step 4: Burning modes (Track at Ounce and Disk at Ounce).
It is then necessary to determine if your CD must be finalised. A CD is finalised when that this one is ended and that they do not intend to top up data any more. The CD will not therefore be able to be changed any more later. The notion of revision for a
réinscriptible CD has no sense since that this last can be erased at pleasure.
Check the hut then 'Ecrire ' and click on the button 'Ecrire ' to throw the engraving.
Before engraving as such, it is possible to simulate process to discern possible errors. Shoot the hut 'Protection against breaks' and check only the hut 'Simulation '. Click on the button 'Simuler ' to test the engraving.
With 'Calculation of the maximum speed', the engraving speed fits automatically following the access time to files to be engraved.
If you check 'Simulation ' (and/or 'Calculation of the maximum speed') as well as 'Write ', if the test took place well, the engraving of the CD will start automatically.
